Key sequence not recognized in Level-D 767
Posted: 20 Feb 2011, 12:53
Hi,
I have set macros for LEVEL-D 767 MCP functions, but they are not "seen" by the LEVEL-D.
Hidmacro.exe sends out the correct keysequence , I have tested that.
I.e I have keyb2 key 3 for AT Arm, key sequence +r sends out LSHFT+r to active window
When keying in Lshift+r directely form either keyb1 or keyb2 the LEVEL-D 767 respond OK.
I have also testes my SAITEK X52 and it works OK, bit not Hidmacros .
Any ideas what I do wrong here. I have tested other keysequences like parking brake CNTL +. and that works OK.
IS it a timing issue?
br
Roar
I have set macros for LEVEL-D 767 MCP functions, but they are not "seen" by the LEVEL-D.
Hidmacro.exe sends out the correct keysequence , I have tested that.
I.e I have keyb2 key 3 for AT Arm, key sequence +r sends out LSHFT+r to active window
When keying in Lshift+r directely form either keyb1 or keyb2 the LEVEL-D 767 respond OK.
I have also testes my SAITEK X52 and it works OK, bit not Hidmacros .
Any ideas what I do wrong here. I have tested other keysequences like parking brake CNTL +. and that works OK.
IS it a timing issue?
br
Roar